Hummer H1 Service Manual page 547

9-10 Axles, Suspension, and Frame
TIE ROD END
SLOTTED NUT
GEARED HUB
Figure 9-16: Tie Rod End Into Geared Hub
VENT LINE
Figure 9-17: Vent Line
11. Secure vent line, speed sensor lead and clamp to geared
hub with washer and bolt. Tighten bolt to 38 lb-ft (52
N•m) (the left side of vehicle uses two p-clamps to secure
the speed sensor lead to the geared hub).
12. Install speed sensor and retaining sleeve into speed sensor
bracket and push in until the sensor touches the tone
wheel.
_________________________________________
GEARED HUB
SPEED
SENSOR
LEAD
GEARED HUB
FITTING
13. Remove fill plug and washer from geared hub
(Figure 9-18).
GEARED HUB
Figure 9-18: Geared Hub Fill Plug
14. Fill geared hub to proper oil level (Section 1).
15. Install washer and fill plug on geared hub. Tighten fill
plug to 8-13 lb-ft (11-18 N•m).
16. Install wheel.
17. Check alignment.
®
FILL PLUG