Hummer H1 Service Manual page 660

_____________________________________________________________________
®
Installation
NOTE: Perform step 1 for two-passenger models only.
1. Secure rear inner kick panel to right rear of tunnel with
panel fastener (Figure 10-52).
2. Secure right front inner kick panel to tunnel with panel
fasteners.
3. Secure left front inner kick panel to tunnel with panel
fasteners.
4. Secure shift control trim panel to tunnel with screw/
washer assemblies and panel fastener.
5. Install center and front consoles.
NOTE: Perform steps 6 and 7 for four-passenger models only.
6. Secure rear inner kick panels with panel fasteners
(Figure 10-51).
7. Secure rear wall trim to rear compartment wall with panel
fasteners and screw/washer assemblies.
8. Connect driver side seat belt buckle electrical connector
(Figure 10-50).
NOTE: Install one seat buckle on two-passenger models.
9. Secure seat buckles to tunnel with washers and bolts.
Tighten bolts to 35-40 lb-ft (47-55 N•m).
10. Install seats.
Outer Kick Panel Replacement
Removal
NOTE: Soft top models require removal of speakers from
front outer kick panels before performing the following task.
1. Remove door stop straps.
2. Remove panel fasteners and right front outer kick panel
from body (Figure 10-53).
3. Remove panel fasteners and left front outer kick panel
from body.
4. Remove panel fasteners and left center outer kick panel
from body.
5. Remove panel fastener and right center outer kick panel
from body.
6. Remove screws, washers, and rear lower seat belt brackets
from body.
7. Remove panel fasteners and left and right rear outer kick
panels from body.
05745159
CENTER KICK
PANEL
FRONT KICK
PANELS
CENTER KICK
PANEL
Figure 10-53: Outer Kick Panel Identification
Installation
1. Secure left and right rear outer kick panels to body with
panel fasteners (Figure 10-53).
2. Secure rear lower seat belt brackets to body with washers
and screws.
3. Secure right center outer kick panel to body with panel
fastener.
4. Secure left center outer kick panel to body with panel
fasteners.
5. Secure left front outer kick panel to body with panel
fasteners.
6. Secure right front outer kick panel to body with panel
fasteners.
7. Install door stop straps.
Body 10-33
PANEL FASTENER
LOWER
SEAT BELT
BRACKET
REAR KICK
PANELS
BODY