Hummer H1 Service Manual page 655

______________________________________________________________________
10-28 Body
Driver's Compartment Trim Replacement
Removal
1. Remove overhead speakers from driver's compartment and
passenger's compartment (if applicable) (Section 12).
2. Remove visors.
3. Remove seat belt assemblies.
4. Remove covers, screws, and grab handle from trim.
(Figure 10-41).
5. Remove screw/washer assemblies and B-bar center trim
from roof.
6. Remove screw/washer assemblies and center trim from
windshield frame and roof (Figure 10-42).
COVER
GRAB
HANDLE
Figure 10-41: Driver's Compartment Trim Replacement
UPPER
B-BAR
TRIM
B-PILLAR
TRIM
Figure 10-42: A-Pillar and B-Bar Interior Trim Identification
7. Remove screw/washer assemblies and upper A-pillar trim
from roof.
8. Remove screw/washer assembly and lower A-pillar trim
from A-pillar.
9. Remove screw/washer assemblies and upper B-bar trim
from roof.
10. Remove screws, washers, and B-pillar trim from B-pillar.
NOTE: Replacement of the rear driver's compartment trim for
2-door vehicles with and without an enlarged cab is basically
the same. Steps 11 through 13 cover 2-door vehicles without
an enlarged cab.
11. Remove seats.
ROOF
CENTER TRIM
UPPER
A-PILLAR
TRIM
A-PILLAR
LOWER
A-PILLAR
TRIM
B-BAR
CENTER TRIM
®