Hummer H1 Service Manual page 896

_____________________________________________________
®
POWER WINDOW AND DOOR LOCKS FRONT
DOOR HARNESS REPLACEMENT
Removal
1. Remove front outer kick panels (Section 10).
2. Remove power window and door lock switches from door.
3. Remove front door trim, vapor barrier, and moisture
barrier flap from door (Section 10).
NOTE: Tag leads for installation.
4. Disconnect 4-way and 6-way harness connectors from
power windows and door locks body harness connectors
(Figure 2-118).
NOTE: Perform step 6 for vehicles equipped with power mir-
rors.
5. Disconnect two harness connectors from power mirrors
body harness connectors.
6. Remove screw, nut and lockwasher assembly, and clamp
securing harness to A-pillar. Discard nut and lockwasher
assembly
7. Remove harness wires from 4-way and 6-way connectors.
NOTE: Lubricate bushings, grommet, and harness teflon
cover with silicone spray.
8. Pull harness through A-pillar rubber grommet.
9. Remove and inspect A-pillar rubber grommet. Replace if
damaged.
NOTE: Perform step 11 for vehicles equipped with power mir-
rors.
05745159
Electrical System
10. Disconnect two harness connectors from power mirrors
door jumper harness connectors (Figure 2-120).
11. Remove self-tapping screw and clamp securing harness to
door reinforcement (Figure 2-120).
12. Remove two self-tapping screws and harness mounting
bracket from door assembly.
13. Pull harness through door bushing.
14. Inspect door bushing and replace if damaged.
15. Remove harness mounting bracket and mounting bracket
bushing from harness. Inspect bushing and replace
if damaged.
16. Disconnect harness connector from power window
regulator (push locking tab up on bottom of connector).
17. Disconnect harness connector from power door locks
actuator.
18. Remove retainer and harness from door assembly.
Figure 2-118: Power Mirrors Door Jumper Harness
12-123
POWER MIRRORS
DOOR JUMPER
HARNESS
CONNECTORS
HARNESS
CONNECTORS
4-1-00