Hummer H1 Service Manual page 669

______________________________________________________________________
10-42 Body
B-PILLAR
REAR DOOR
DOOR WINDOW SEAL
BELTLINE
SEAL
FRONT
CHANNEL
CHANNEL
Figure 10-72: Window Channel Locations
DOOR STOP
BRACKET
DOOR STOP
BRACKET
Figure 10-71: Door Stop Strap Assembly
REAR
A-PILLAR
STRAP
Cleaning and Inspection
NOTE: Clean all components, examine for wear or damage,
and replace if necessary.
Remove all glass remains from channels and bottom of door
(Figures 10-72 and 10-73).
Installation
1. Insert glass/lower channel bracket assembly into door
through window opening at 90° from installed position.
2. Rotate glass/lower channel bracket assembly so that it is
aligned with the appropriate channels (Figure 10-73)
3. Install glass in front and rear channels and channel
brackets, and secure channels and channel brackets to door
with four lockwashers and screws (Figure 10-72).
4. Install upper and lower window channels.
5. Install window regulator.
6. Operate window several times to ensure glass is properly
aligned.
DOOR STOP
DOOR
BRACKET
FRONT DOOR
®