Hummer H1 Service Manual page 716

_____________________________________________________________________
®
Slant Door Latch
DOOR HANDLE
ASSEMBLY
DOOR HANDLE
GASKET
LOCK
ACTUATOR
LOCK
ACTUATOR
BRACKET
LOCK
ACTUATOR
RETAINING BOLT
Figure 10-178: Slant Door Latch and Handle Break-
Removal
1. Remove the slant door trim.
2. Disconnect the latch actuator cable from the slant door
handle assembly by removing the retaining nut, and bolt
(Figure 10-178).
3. Remove the four latch bracket mounting nuts and bolts.
4. Move the lock actuator to the side and remove the latch
and bracket assembly.
5. Remove the three bolts and nuts that are securing the latch
to the bracket.
Installation
1. Install the slant door latch to the bracket using the previ-
ously removed door latch hardware (Figure 10-178).
Tighten the latch bolts to 12 lb-ft (16 N.m).
2. Align the lock actuator bracket and the latch mounting
bracket with the door and install the four retaining bolts.
Do not tighten at this time (See Adjustments).
3. Connect the latch actuator cable to the door handle.
4. Adjust the door latch (See Adjustments).
5. Install door trim (See Section 10).
05745159
RETAINING
BOLT
DOOR
HANDLE
HARDWARE
LATCH
ACTUATOR
CABLE
NUT
LATCH
MOUNTING
BRACKET
BRACKET
MOUNTING
BOLTS
LATCH
MOUNTING
BOLTS
SLANT DOOR
LATCH
00-P12-014
down
Adjustments
1. Loosen the four latch bracket mounting bolts until the
latch moves horizontally and vertically (Figure 10-178).
2. Position the latch so the striker is centered in the opening
of the latch. The door should latch easily and have
minimal movement.
3. Tighten the four latch mounting bracket nuts and bolts to
15 lb-ft (20 N.m).
4. Verify the latch is operating correctly.
Slant Door Lock Actuator
ACTUATOR
ROD
LOCK
ACTUATOR
LOCK ACTUATOR
RETAINING SCREW
Figure 10-179: Slant Door Lock Actuator Replacement
Removal
1. Remove the slant door trim (See Section 10).
2. Remove the lock
(Figure 10-179).
3. Disconnect the lock actuator rod from the slant door
handle assembly.
Installation
1. Connect the lock actuator rod to the slant door handle
assembly (Figure 10-179).
2. Secure the door lock actuator to the bracket with the lock
actuator retaining screw.
3. Install the door trim (See Section 10).
Body 10-89
LOCK ACTUATOR
MOUNTING BRACKET
actuator retaining screw
4-1-00