Hummer H1 Service Manual page 680

_____________________________________________________________________
®
HORN
Horn Replacement
Removal
1. Remove harness connectors and adapters from horn.
2. Remove nut and
(Figure 10-101).
NOTE: Overtightening horn mounting nut will distort the horn
bellows and result in an "off-key" horn tone.
Installation
1. Secure horns to mounting bracket with nuts.
2. Plug harness connectors and adapters into horns.
HORN
NUT
MOUNTING
BRACKET
Figure 10-101: Horn and Horn Mounting Bracket
Replacement
Horn Mounting Bracket Replacement
Removal
1. Remove two horns.
2. Remove bolts, washers, lockwashers, nuts, and horn
mounting bracket from airlift bracket (Figure 10-101).
Installation
1. Secure horn mounting bracket to airlift bracket with bolts,
washers, lockwashers, and nuts (Figure 10-101).
2. Install two horns.
05745159
horn from mounting bracket
NUT
HORN
ADAPTERS
HARNESS CONNECTORS
WINDSHIELD ASSEMBLY
Windshield Glass and Weatherstrip
Replacement
Removal
1. Remove windshield wiper arm and blade.
2. Remove six bolts and upper retainer from windshield
frame (Figure 10-102).
3. Remove four bolts and center retainer from windshield
frame.
4. Remove four bolts and lower retainer.
5. Remove weatherstrip and glass from windshield frame.
6. Clean sealing compound from windshield frame.
Installation
1. Apply a 1/8 in. (3 mm) bead of sealing compound to edge
of glass and windshield frame (Figure 10-102).
2. Position weatherstrip on glass.
3. Position glass and weatherstrip to windshield frame with
center retainer and four bolts.
4. Secure upper retainer to windshield frame with six bolts.
5. Secure lower retainer to windshield frame with four bolts
6. Apply a thin bead of sealing compound to top edge of
outside weatherstrip.
7. Install windshield wiper arm and blade.
WEATHERSTRIP
UPPER
RETAINER
CENTER
RETAINER
LOWER RETAINER
Figure 10-102: Windshield Glass Replacement
Body 10-53
WINDSHIELD
GLASS FRAME