Hummer H1 Service Manual page 1175

110 PCM/Tech 1 Scan Tool
DTC P1621 EEPROM Write
Step
1 Important: Before clearing DTC(s) use the scan tool "Capture Info" to
record freeze frame and failure records for reference, as data will be lost
when "Clear Info" function is used.
Was the "On-Board Diagnostic (OBD) System Check" performed?
2 Replace the faulty PCM. Notice: If the PCM is faulty, the new PCM must
be programmed. Go to PCM replacement and programming procedures.
Is the action complete?
3 1. Using the Scan Tool, select "DTC", "Clear Info".
2. Start engine and idle at normal operating temperature.
3. Select "DTC", "Specific", then enter the DTC number which was set.
4. Operate vehicle within the conditions for setting this DTC as specified
in the supporting text.
Does the Scan Tool indicate that this diagnostic Ran and Passed?
4 Using the Scan Tool, select "Capture Info", "Review Info".
Are any DTCs displayed that have not been diagnosed?
DTC P1627 - A/D Performance
Step
1 Important: Before clearing DTC(s) use the scan tool "Capture Info" to
record freeze frame and failure records for reference, as data will be lost
when "Clear Info" function is used.
Was the "On-Board Diagnostic (OBD) System Check" performed?
2 Replace the faulty PCM. Notice: If the PCM is faulty, the new PCM must
be programmed. Go to PCM replacement and programming procedures.
Is the action complete?
3 1. Using the Scan Tool, select "DTC", "Clear Info".
2. Start engine and idle at normal operating temperature.
3. Select "DTC", "Specific", then enter the DTC number which was set.
4. Operate vehicle within the conditions for setting this DTC as specified
in the supporting text.
Does the Scan Tool indicate that this diagnostic Ran and Passed?
4 Using the Scan Tool, select "Capture Info", "Review Info".
Are any DTCs displayed that have not been diagnosed?
___________________________________________________
Action
Action
Value(s) Yes
— Go to Step 2.
— Go to Step 3.
— Go to Step 4.
— Go to the
applicable
DTC table
Value(s) Yes
— Go to Step 2.
— Go to Step 3.
— Go to Step 4.
— Go to the
applicable
DTC table
®
No
Go to OBD
System Check.
—
Go to Step 2.
System OK.
No
Go to OBD
System Check.
—
Go to Step 2.
System OK.