Hummer H1 Service Manual page 1049

13-44 Accessories
STAINLESS STEEL UPPER GRILLE COVER
REPLACEMENT
Removal
1. Remove the six screws, washers and nuts securing the SS
grille frame to the original grille frame and remove the SS
grille frame (See Figure 13-85).
SS
GRILLE
FRAME
Figure 13-85: SS Upper Grille Frame R&I
2. Peel the eight SS grille slats off from the original grill slats
and remove the double-sided tape with an adhesive
remover.
Figure 13-86: SS Upper Grille Slat R&I
Installation
1. Clean all the original and SS grille slats with alcohol.
2. Place the SS grille frame over the original grille frame and
loosely install the six SS screws, washers and nuts.
3. Use an alternate tightening sequence and torque the screws
to 7 lb-ft (9 N•m).
_____________________________________________________________
SCREW
HOLE
SS SLAT
ROLL
INTO
PLACE
4. Place two 3 inch pieces of double-sided tape on the back
side of the eight SS slats, approximately 2 inches from
each end of the slat.
5. Starting with the bottom grille slat, peel the backing off
the double-sided tape and hook the front edge of the SS
slat on the front edge of the original slat and roll the SS
slat into place. Press and hold momentarily to ensure a
good bond.
6. Continue installing the remaining slats noting that the
fourth slat has the tab to cover the grille mesh mounting
screw area.
STAINLESS STEEL WHEEL COVER REPLACE-
MENT
Removal
1. Locate the two lugnut simulators that can be turned by
hand and remove the simulators and the plastic inserts.
2. Remove the two nuts and washers securing the wheel
cover to the mounting brackets and remove the cover.
3. Remove the bolts, lockwashers and washers securing the
mounting brackets and CTIS tube shield (if equipped)
from the spindle and remove the brackets and shield.
LUG NUT
SIMULATOR
PLASTIC
INSERT
Figure 13-87: Wheel Cover Replacement
Installation
1. Install the two wheel cover mounting brackets and CTIS
tube shield (if equipped) on the spindle with four bolts,
lock washers and washers. Torque the bolts to 37 lb-ft (50
N•m).
2. Place the wheel cover over the studs on the mounting
brackets and install the nuts and washers. Torque the nuts
to 8-13 lb-ft (11-18 N•m).
3. Install the plastic inserts and the lug nut simulators.
CTIS
WHEEL
TUBE
COVER
SHIELD
MOUNTING
SPINDLE
BRACKET
®