Hummer H1 Service Manual page 706

_____________________________________________________________________
®
Side Marker Light Lens and Lamp
Replacement
Removal
Remove two screws, cover, lens, and lamp from lamp holder
(Figure 10-154).
Installation
1. Install lamp. Secure lens, and cover to lamp holder with
two screws (Figure 10-154).
2. Ensure side marker light operates properly.
LAMP HOLDER
LAMP
Figure 10-154: Side Marker Light Lens and Lamp
Replacement
Identification Light Replacement
NOTE: All identification lights are replaced the same. Bulb is
not removable from lens. Light is replaced as an assembly.
Removal
1. Carefully pry tabbed sides of identification light from light
bracket (Figure 10-155).
2. Disconnect light from wiring harness.
Installation
1. Connect identification light to wiring harness
(Figure 10-155).
2. Snap light into light bracket.
05745159
LENS
COVER
LIGHT BRACKET
WIRING HARNESS
TABBED
SIDE
Figure 10-155: Identification Light Replacement
Side Marker Light Assembly Replacement
NOTE: Replacement of front and rear light assemblies is basi-
cally the same. This procedure covers the front left side
marker.
Removal
1. Remove four screws, washers, and close-off cover from
hood (Figure 10-156).
2. Disconnect harness lead from marker light lead
(Figure 10-157).
3. Remove two screws, cover, and lens from marker light.
4. Remove four locknuts, washers, ground lead, gasket, four
screws, and marker light from hood.
MARKER
LIGHT
HOOD
Figure 10-156: Close-Off Cover Location
Body 10-79
TABBED
SIDE
IDENTIFICATION
LIGHT
CLOSE-OFF COVER