Hummer H1 Service Manual page 901

12-128 Electrical System
7. Connect harness connector to power window regulator
(Figure 2-123).
8. Connect harness connector to power door lock actuator.
9. Secure harness to door reinforcement with clamp and self-
tapping screw.
10. Secure harness to door assembly with retainer.
11. Secure harness to door assembly with tie strap.
12. Install moisture barrier flap, vapor barrier, and door trim
panel on door (Section 10).
13. Install power windows switch on door.
14. Install lower B-pillar trim and center kick panel (Section
10).
15. Connect battery ground cable (Section 12).
16. Check power windows and door locks for proper
operation.
17. Remove nut and ground lead from ground stud.
18. Disconnect two window and lock harness connectors from
door harness connectors (Figure 2-125).
19. Repeat step 10 for opposite side.
20. Remove B-pillar lower trim from both sides of the vehicle.
21. Disconnect lock and window harness connector from rear
door harness connector (HMCS, HMC4, HMCO)
22. Repeat step 12 for opposite side (HMCS, HMC4, HMCO).
23. Disconnect vertical door lock jumper from window and
door lock harness on the passenger side.(HMCS)
24. Remove tie straps securing harness to vehicle body
harness and remove harness. Discard tie straps.
Installation
1. Route harness through instrument panel and along A- pil-
lar to both sides of vehicle.
2. Connect harness connector to rear door harness connectors
on both sides of vehicle (HMCS, HMC4, HMCO).
3. Connect vertical door lock jumper to window and door
lock harness on the passenger side.(HMCS)
4. Connect two front lock and window harness connectors to
door harness connectors on both sides of vehicle.
5. Install ground lead on ground stud with nut.
6. Connect two lock and window harness leads to vehicle
body harness power leads.
7. Connect two power windows and door locks harness
connectors to receiver harness connectors.
8. Secure harness to vehicle body harness with tie straps.
9. Install CTIS gauge panel
10. Install tachometer and clock harness into instrument panel
11. Install two gauge panels on instrument panel with eight
screws (Section 12).
12. Install console cover (Section 10).
13. Install front outer kick panels (Section 10).
4-1-00
______________________________________________________
14. Install crash pad (Section 10).
15. Check power windows and door lock for proper operation
A-PILLAR
Figure 2-125: Door Harness Connectors
®
WINDOW AND
LOCK HARNESS
CONNECTORS
DOOR HARNESS
CONNECTORS