Hummer H1 Service Manual page 1031

13-26 Accessories
Roof Rack Clamp Replacement
Removal
4. Loosen support screw on clamp securing clip to clamp
(Figure 13-58).
5. Loosen locknut securing clip to drip rail.
6. Remove clip from under drip rail.
7. Remove locknut, washer, capscrew, and clamp from roof
rack.
Installation
1. Install clamp on roof rack with capscrew, washer, and
locknut.
2. Position clip under drip rail and over support capscrew.
3. Tighten locknut securing clip to drip rail to 20-25 lb-in (2-
3 N•m).
4. Tighten support screw on clamp. Tighten locknut installed
in step 1 to 25 lb-ft (34 N•m).
DRIP RAIL
SUPPORT SCREW
Figure 13-58: Roof Rack Clamp
_____________________________________________________________
SIDE
RACK END
CLAMP
CLIP
®