Hummer H1 Service Manual page 1010

______________________________________________________________
®
Inspection
1. Inspect drum for damage to splined end flanges and tube
(Figure 13-12). Replace winch if damaged.
DRUM SUPPORT
MOTOR END
THRUST
WASHER
DRIVE
SHAFT
GASKET
GEAR
HOUSING
Figure 13-12: Drum Assembly and Gear Housing
Assembly
2. Inspect gear end and motor end drum supports for damage.
Replace if damaged.
3. Inspect gear housing for damage. Replace if damaged.
4. Inspect thrust plate for damage or wear. Replace if
damaged or worn. Apply grease on thrust plate for
assembly.
5. Inspect clutch lever and driveshaft for damage. Replace if
damaged.
6. Inspect gear teeth and machined surfaces of intermediate
ring gear for damage. Replace if damaged.
7. Inspect gear teeth, splines, and machined surfaces of
output ring gear, output gear carrier, intermediate gear
carrier, and input gear carrier assembly for damage.
Replace any damaged parts (Figure 13-13).
05745159
DRUM
THRUST
WASHER
DRUM SUPPORT
GEAR END
GEAR CARRIER
(THIRD STAGE)
INPUT
GEAR CARRIER
ASSEMBLY
(FIRST STAGE)
INTERMEDIATE
GEAR CARRIER
SUN
(SECOND STAGE)
GEAR
Figure 13-13: Gear Carriers
8. Inspect brake assembly for damage (Figure 13-18).
9. Inspect motor, spline, mating surface, and terminals for
damage. Replace motor if damaged (Figure 13-14).
COVER
CONTROL
MOTOR
Figure 13-14: Motor and Control Unit
10. Inspect cover for damage. Replace if damaged.
11. Inspect control for damaged leads and damaged mounting
base. Replace control if damaged.
Accessories 13-5
OUTPUT
ASSEMBLY
OUTPUT
RING GEAR
ASSEMBLY
CLAMP
DRUM
SUPPORT
LEAD
00-S13-007
SPACER
SPLINE