Glovebox Replacement - Hummer H1 Service Manual

_____________________________________________________________________
®
Tachometer Replacement
NOTE: Mark position of set screws in relationship to tachom-
eter clock panel before disassembly. Tachometer mounting
clamp must be installed in factory position to have proper
clearance for reassembly.
NOTE: It may be necessary to remove clock for access to ta-
chometer mounting clamp hardware.
Removal
1. Remove screws and tachometer/clock panel from I.P.
2. Unplug tachometer electrical connector from I.P. wiring
harness.
3. Loosen set screws and tachometer mounting clamp
hardware. Remove clamp from tachometer housing.
4. Remove tachometer from tachometer/clock panel.
Installation
1. Position tachometer in tachometer/clock panel.
2. Slide tachometer mounting clamp onto tachometer
housing; close enough to tachometer/clock panel for set
screws to make contact.
3. Tighten clamp securely onto tachometer body and tighten
setscrews until they contact tachometer/clock panel.
4. Plug tachometer electrical connector into I.P. wiring
harness.
5. Secure tachometer/clock panel to I.P. with screws.
TACHOMETER/CLOCK
TACHOMETER
MOUNTING
SET SCREW
CLAMP
TACHOMETER
MOUNTING
CLAMP
HARDWARE
CLOCK MOUNTING
CLAMP
Figure 10-22: Tachometer Mounting
05745159
TACHOMETER
PANEL
CLOCK
6-S10-018.1
CIGARETTE LIGHTER REPLACEMENT
Removal
1. Pull front console away from dashpad enough to gain
access to wiring harness connector.
2. Remove wiring harness connector from lighter assembly.
3. Remove element from lighter assembly heater (Figure 10-23).
4. Remove shell from heater, and remove shell, heater, and
bezel from console.
Installation
1. Install bezel and heater in console (Figure 10-23).
2. Install shell on heater.
3. Install wiring harness connector on lighter assembly.
4. Install element in lighter assembly.
5. Engage cigarette lighter to ensure proper operation.
6. Install front console.
WIRING HARNESS
CONNECTOR
SHELL
CONSOLE
Figure 10-23: Cigarette Lighter Breakdown

GLOVEBOX REPLACEMENT

Removal
Remove screws and glovebox from front console (Figure 10-24).
Installation
Secure glovebox to front console with screws (Figure 10-24).
GLOVEBOX
Figure 10-24: Glovebox
Body 10-19
BEZEL
HEATER
ELEMENT
LIGHTER
ASSEMBLY
FRONT CONSOLE