Hummer H1 Service Manual page 528

_________________________________________________________
®
FIRST
INDEX
MARK
(ON
HOUSING)
Figure 8-66: Placing First Index Mark On Housing
6. Measure back counterclockwise 1/2 inch (13 mm) from
first index mark and scribe a second index mark on gear
housing (Figure 8-67).
SECOND
INDEX
MARK
(1/2" FROM
FIRST MARK)
Figure 8-67: Placing Second Index Mark
On Housing
7. Back off adjuster plug to second index mark
(Figure 8-71). Be sure hole in adjuster plug is aligned with
second mark before proceeding.
05745159
SPANNER
WRENCH
HOLE IN
ADJUSTER
PLUG
SECOND
MARK
Figure 8-68: Backing Off Adjuster Plug To Second
8. Install adjuster plug locknut. Hold adjuster plug from
turning with spanner wrench while tightening locknut. Tap
locknut with hammer to tighten. Then use punch to secure
nut (Figure 8-69).
ADJUSTER
PLUG
Figure 8-69: Securing Adjuster Plug Locknut
9. Verify that adjuster plug position remained unchanged
during installation. Loosen locknut and reset plug position
if necessary.
Steering System
FIRST
MARK
SPANNER
WRENCH
J–7624
Index Mark
PUNCH
NOTCH
LOCK NUT
8-37
4-1-00