Hummer H1 Service Manual page 652

_____________________________________________________________________
®
REMOVABLE LOAD BARRIER AND MOUNTING
BRACKETS REPLACEMENT (STATION WAGON)
Removal
1. Remove drive screws and carpet assembly from front and
back of removable load barrier (Figure 10-35).
2. Remove necessary interior trim to gain access to mounting
brackets.
3. Remove removable load barrier by lifting barrier up and
out of mounting brackets on inner wheel house panels.
4. Remove rivets and mounting bracket from left inner wheel
house panel.
5. Remove rivets and mounting bracket from right inner
wheel house panel.
Inspection
Inspect bumper strips. If damaged, replace.
Installation
1. Secure mounting bracket to left inner wheel house panel
with rivets (Figure 10-35).
2. Secure mounting bracket to right inner wheel house panel
with rivets.
3. Install removable load barrier in mounting brackets.
4. Install interior trim.
5. Secure carpet assembly to front and back of removable
load barrier with drive screws.
REMOVABLE
LOAD BARRIER
DRIVE
SCREW
BUMPER STRIPS
CARPET ASSEMBLY
Figure 10-35: Removable Load Barrier
Location
05745159
RIGHT INNER WHEEL
HOUSE PANEL
MOUNTING
BRACKET
RIVET
INTERIOR TRIM
B-Bar Replacement
NOTE: This procedure covers replacement of the B-bar for all
vehicles except open top models and 2-door models without an
enlarged cab.
Removal
1. Remove seat belt assemblies.
2. Remove trim from B-bar.
3. Remove domelight.
NOTE: It may be necessary to remove any duct tape or tie
straps securing electrical wiring harnesses to B-bar.
4. Remove screws, washers, and headliner support from B-
bar (Figure 10-36).
5. Remove screws, lockwashers, and mounting brackets from
mounting blocks.
6. Remove B-pillar seals and rabbet seals from B-pillar.
Inspect and discard seals if damaged.
7. Remove locknuts, washers, and strikers from B-pillar.
8. Remove six locknuts, washers, bolts and mounting blocks
from B-pillar.
9. Remove B-bar.
10. Remove screws, washers, and two trim mounting brackets
from B-bar.
TRIM
MOUNTING
BRACKET
STRIKER
MOUNTING
BRACKET
RABBET
SEAL
Figure 10-36: B-Bar Mounting
Body 10-25
B-BAR
HEADLINER
SUPPORT
B-PILLAR
SEAL
MOUNTING
BLOCK
B-PILLAR