Hummer H1 Service Manual page 836

______________________________________________________
®
Crashpad Replacement (Right Side)
Removal
1. Remove screw/washers, and crashpad from dashboard
(Figure 2-84).
2. Disconnect air hose from vent duct.
3. Remove screws, side window vent, and vent duct from
crashpad.
Installation
1. Secure vent duct and window vent to crashpad with screws
(Figure 2-84).
2. Connect air hose to vent duct.
3. Secure crashpad to dashboard with screw/washers.
DASHBOARD
I. P. CLIPS
CONSOLE
CRASH PAD
VENT
(LEFT SIDE)
Figure 2-84: Crashpad Replacement
Crashpad Replacement (Left Side)
Removal
1. Remove screw/washers from top of crashpad.
2. Tug gently on crashpad toward steering wheel to free
crashpad clips from I. P. clips (Figures 2-83 and 2-84).
3. Lift vent side of crashpad and work console side (duct
nozzle) out of front console.
Installation
1. Work console side (duct nozzle) of crashpad into front
console plenum.
2. Position crashpad on edge of I. P. closest to steering wheel
and push crashpad onto I. P. clips (Figures 2-83 and 2-84).
3. Secure crashpad to I. P. with screw/washers.
05745159
VENT
DUCT
AIR HOSE
DUCT
NOZZLE/
SIDE
WINDOW
VENT
CRASH PAD
(RIGHT SIDE)
Electrical System
Gauge Replacement
NOTE: Gauge replacement is basically the same for all instru-
ment panel gauges.
Removal
1. Remove screws and pull gauge panel away from instru-
ment panel (Figure 2-85).
2. Disconnect lamp connector from gauge.
NOTE: Tag all leads prior to removal for installation.
3. Remove nut and lockwasher assemblies securing three
leads to gauge.
4. Remove hold-down bracket.
5. Remove gauge through front of gauge panel.
GAUGE PANEL
HOLD-DOWN
BRACKET
GAUGE
Figure 2-85: Gauge Replacement
Installation
1. Insert gauge through front of gauge panel (Figure 2-85).
2. Secure hold-down bracket and lead to gauge with nut and
lockwasher assembly.
3. Secure leads to gauge with nut and lockwasher assemblies.
4. Connect lamp connector to back of gauge.
5. Start engine and ensure gauge operates properly.
6. Secure gauge panel to instrument panel with screws.
12-65
LAMP
CONNECTOR
INSTRUMENT
PANEL
LEAD
LEADS
4-1-00