Hummer H1 Service Manual page 681

______________________________________________________________________
10-54 Body
Windshield Assembly Replacement
WARNING: To avoid injury, or damage to equipment,
support windshield during removal and installation.
Removal
1. Remove soft top or loosen roof assembly, as applicable.
2. Remove windshield wiper blade and arm.
3. Remove windshield wiper linkage.
4. Remove windshield wiper arm pivots.
5. Remove two locknuts and bolts securing windshield
assembly to A-pillar (Figure 10-103).
WINDSHIELD
ASSEMBLY
A-PILLAR
Figure 10-103: Windshield Assembly Mounting
6. Disconnect roof harness, wiper motor, heated windshield,
clearance light and compass mirror connections at center
pillar and pull harness loose from windshield center pillar
(Figure 10-104).
7. Remove six bolts and washers securing windshield
assembly to two brackets (Figure 10-103).
8. Remove windshield assembly from A-pillar.
9. Remove two seals from windshield assembly.
10. Clean remains of seals from windshield.
SEALS
BRACKET
ROOF
HARNESS
HEATED
WINDSHIELD
Figure 10-104: Wiring Harness Lead Location
Disassembly
NOTE: Perform steps 1 and 2 for open-top models. Perform
step 3 for all other models.
1. Remove eleven rivets, former, and seal from windshield
assembly (Figure 10-105).
2. Remove eight rivets and two corner caps from windshield
assembly, and replace if damaged.
3. Remove thirteen rivets, former, and seal from windshield
assembly (Figure 10-105).
4. Clean remains of seal from windshield assembly.
Assembly
NOTE: Perform steps 1 and 2 for open-top models. Perform
step 3 for all other models.
1. Secure seal and former to windshield assembly with
eleven rivets (Figure 10-105).
2. Secure two corner caps to windshield assembly with eight
rivets.
3. Secure seal and former to windshield assembly and secure
with thirteen rivets (Figure 10-105).
®
WIPER
MOTOR
COMPASS
MIRROR
CLEARANCE
LIGHT
9-S12-102