Hummer H1 Service Manual page 714

_____________________________________________________________________
®
SLANT BACK AND COMPONENTS
ROOF
SHELL
Slant Door and Torsion Assembly Replace-
ment
CAUTION: The slant door is heavy. Some assistance will be
required for removal and installation.
Removal
1. Remove all the trim on the door (See Section 10).
2. Disconnect the lock solenoid, the rear window defrost, and
the wiper motor harness connectors.
3. Carefully remove the harness from the slant door.
4. Using an assistant carefully support the door while
removing the door mounting bolts
Remove the door.
5. Remove all of the interior trim pieces that cover the
torsion assembly.
6. Disconnect the cargo light switch harness connection.
7. Remove both nuts, bolts and washers that secure the
torsion assembly to the intermediate C-pillar.
8. Remove six torsion assembly mounting bolts and washers.
9. Carefully remove the torsion assembly.
05745159
DOOR
MOUNTING
SLANT BACK
BOLTS
TORSION
ASSEMBLY
Figure 10-176: Slant Door and Torsion Assembly
(Figure 10-176).
Installation
1. Using the torsion assembly mounting hardware, install the
torsion assembly (Figure 10-176). Do not fully tighten at
this time (See Adjustments).
2. Connect the cargo light switch harness connection.
3. Secure the torsion assembly to the intermediate C-pillar
using a nut, lock washer and bolt on both the left and right
sides.
4. Using an assistant, carefully install the slant door with the
door mounting hardware. Do not fully tighten at this time
(See Adjustments).
5. Route and secure the harness to the slant door as
illustrated.
6. Connect all electrical components making sure not to
damage any terminals in the connectors.
7. Adjust the torsion assembly (See Adjustments).
Body 10-87
SLANT DOOR
WIRING HARNESS
INTERMEDIATE
C-PILLAR
TORSION
ASSEMBLY
TORSION ASSEMBLY
MOUNTING BOLTS
00-S10-003
4-1-00