Hummer H1 Service Manual page 1047

13-42 Accessories
REMOTE ENTRY TRANSMITTER BATTERY
REPLACEMENT
1. Remove the screw in the back of the transmitter
(See Figure 13-81).
2. Using a small screw driver or a knife blade, carefully pry
the two halves of the transmitter apart exposing the
battery.
3. New batteries can be obtained from an electronics supply
store. The battery size is 27A 12V.
4. Carefully pry the battery out and install the new battery.
Match the polarity markings on the transmitter casing and
the battery when installing.
5. Snap the transmitter case halves together and install the
screw in the back of the transmitter.
6. Test the operation of the remote entry transmitter.
SCREW
Figure 13-81: Remote Entry Battery Replacement
_____________________________________________________________
TRANSMITTER
CASE
BATTERY
9-S13-017
STAINLESS STEEL FRONT BUMPER COVER
(WITH BRUSHGAURD AND W/O WINCH)
Removal
1. Remove two bolts and the licence plate mount bracket
(See Figure 13-82).
2. Remove four bolts, washers and two tow bracket/lifting
shackle assemblies.
3. Pull the SS cover free from the bumper and clean the
double sided foam tape from the cover and bumper.
LICENCE
BRACKET
LIFT
SHACKLE
Figure 13-82: SS Front Bumper Cover W/O Winch
Installation
1. Clean all grease and dirt from the front bumper and cover
and prep the surfaces with alcohol.
2. Apply new double sided foam tape to the back of the cover
and press the cover on the bumper.
3. Install two tow bracket/lifting shackle assemblies, four
bolts and washers. Torque the bolts to 90 lb-ft (122 N•m).
4. Install the licence plate mounting bracket with two bolts
and torque to 8-13 lb-ft (11-18 N•m).
BUMPER
SS COVER
TOW
BRACKET
®