Hummer H1 Service Manual page 787

12-16 Electrical System
BATTERY CABLE REPLACEMENT
Battery Negative Cables - Removal
1. Remove caps from battery negative cable (Figure 12-27).
2. Remove battery cable bolts.
3. Disconnect winch negative cable, if equipped (Figure 12-27).
NEGATIVE CABLE
TO STARTER
BOOT
CABLE BOLT
BATTERY
NEGATIVE
CABLE
4. Remove fasteners securing negative cable to cable hanger
and starter then remove negative cable (Figure 12-28).
CABLE
HANGER
NEGATIVE
BATTERY CABLE
Figure 12-28: Negative Cable to Cylinder Block
Attachment
4-1-00
_______________________________________________________
BATTERY
CABLE
BOLT
Figure 12-27: Battery Negative Cable Connections
STARTER
POSITIVE
BATTERY
CABLE
ENGINE
HARNESS
CABLE
BOLT
WITH WINCH ONLY
Battery Negative Cables - Installation
1. Connect negative cables to starter, cable hanger, and bat-
teries.
2. Tighten battery cable bolts to 8-12 lb-ft. (11-16 N•m).
3. Install caps on battery cable bolts.
Battery Positive Cable - Removal
1. Disconnect battery negative cables.
2. Remove caps from battery positive cable(s) (Figure 12-29).
3. Disconnect starter cable at battery.
4. Disconnect battery positive cable, and winch cable, if
equipped, at battery.
5. Remove locknut, washer, capscrew, and clamp securing
starter cable to bracket.
6. Disconnect starter cable at starter.
CAP
WINCH
NEGATIVE CABLE
BATTERY
NEGATIVE
CABLE
®