Adjusting The Left/Right Margin (Manual Feed Tray) - Canon iR C3200 Series Service Manual

Moving the adjusting
plate to the right
Decrease the margin at
the front of the paper.
F-15-11
- For output from each cassette, check to make
sure that the margin (L1) along the leading edge
is 2.5±1.5 mm; if not, make the following
adjustments:
1) Make the following selections in service mode:
COPIER>ADJUST>FEED-ADJ>REGIST.
2) Change the setting to make adjustments.
(A change of '1' will cause a shift of 0.1 mm, and a
higher value will move the image toward the
leading edge.)
L1
Image
Increasing the value of FEED-ADJ will move
the image toward the leading edge of the paper.
F-15-12
- Adjusting the Image Area (non-image width)
1) Make the following selections in service mode:
COPIER>ADJUST>BLANK>BLANK-T/L/B/R.
2) Change the setting to make adjustments.
(An increase by '24'increases the non-image width by
about 1mm, with the range of settings being between
0 and 100.)
Image
15.1.4 Adjusting the Left/
Right Margin (Manual
Feed Tray)
Loosen the 2 screws [1], and move the position of the
slide guide [2] to make adjustments.
F-15-13
15.1.5 Adjusting the Left/
Right Margin (Side Paper
Deck)
1) Slide out the compartment, and adjust the position
of the latch plate [1] of the compartment opening
solenoid (SL102) using the 2 screws. (When doing
so, refer to the index [3] on the latch plate.)
[1]
F-15-14
Chapter 15
0000-5348
0000-5349
[3] [2]
(left rear of compartment)
15-3