Chapter 18
18.5.2 FEEDER
18.5.2.1 SENS-INT
Caution
Note
Operation method
18.5.3 FUNCTION (operation/inspection mode): Level 2
18.5.3.1 COPIER
18.5.3.1.1 LASER
LD-ADJ-Y/M/C
Operating
Instructions
18-88
T-18-83
Used to adjust the initialization of ADF sensors.
Execute this item when you have replaced the ADF controller
PCB, document placement sensor, pre-registration sensor, final
document detection sensor or reverse outlet sensor.
See the DIP switch function list in Chapter 5,
"Troubleshooting"in the DADF-D1/K1 Service Manual.
1) Paste black paper (solid black) on the final document
detection sensor in the document tray.
(Make sure the black paper doesn't cover the document
placement sensor. The document placement display LED
must not light.)
2) Close the ADF, select this item, then press the OK key.
3) After about 15 seconds, the document detection LED flashes
twice. When <SERVICE> in the display changes to
<READY>, automatic adjustment is finished.
(<SERVICE> appears at the top right of the display during
automatic adjustment.)
T-18-84
Making the tilt correction motor return to the initial position
automatically.
1) Select this mode.
2) Press the OK key.
- The operation starts. It automatically stops when it is
completed.
0000-5433
0007-5909