Chapter 18
18.5 FUNCTION (Operation/Inspection Mode)
18.5.1 COPIER
18.5.1.1 INSTALL
18.5.1.1.1 CARD
Used to make card reader installation settings.
Setting values
Operation method
18.5.1.2 CCD
18.5.1.2.1 CCD-ADJ
Operation method
MEMO:
When you turn the main power switch ON, the same automatic adjustment operation done by this item is performed.
18-82
T-18-68
1 to 2001 (Value at time of factory shipment/value after
RAM clear: 1)
Enter the number of cards to use.
(You can use up to 1,000 cards from the entered number.)
Initialize the card management information.
- Initialize the card name (department ID) (from the entered
number).
- Initialize the card's password.
T-18-69
Adjusts gain of analog processor unit (in CCD PCB).
1) Select this item.
2) Press the OK key.
The operation starts. When the operation finishes, it stops
automatically.
0000-5421
0000-5422