Removing The High-Voltage Unit - Canon iR C3200 Series Service Manual

Chapter 9
9.8.1.13 Removing the High-
Voltage Unit
1) Disconnect all connectors of the high-voltage unit;
then, remove the 5 screws [1], and detach the high-
voltage unit [2].
F-9-60
2) Remove the 6 screws [1], and remove the base plate
[2]; then, detach the high-voltage unit [3].
F-9-61
9.8.1.14 Removing the Manual
Feed Cooling Fan Duct
1) Slide out the manual fee unit; then, disconnect the
connector [1] and remove the 2 screws [2] to detach
the manual feed cooling fan duct [3].
9-52
0000-4626
9.8.1.15 Removing the Drum
ITB Motor Mounting
Points to Note When Removing the Drum ITB
Motor Mounting
To remove, put your hand into the inside where you
have slid out the manual feed unit; then, while holding
down the swing plate [1] found to the rear of the drum
drive unit, remove from the machine's rear side plate.
The drum drive unit is hooked on the protrusion from
the rear side plate; lift it slightly to detach.
0000-4627
1) Free the DC harness [1] found at the front of the
drum ITB motor base from the cable clamp [2].
F-9-62
0000-4628
F-9-63