Canon iR C3200 Series Service Manual page 887

16.3.7.1.14 Message like 'Check the settings for the server.' is displayed when attempting to send
push scan to computer; push scan to Inbox is available
[ Manual-related ]
Field Remedy
If push scan to any Inboxes can be sent, the Resolution Switching Board and the sending function operate
normally. So, check the settings for the file server on the network. Refer to the Network Guide, on page 3-46
for FTP server, and on page 5-16 for configuration of the shared folder for Windows.
How to send push scan to any Inboxes:
Place a document> Press [Send] tab> Press [Store in User Inbox]> Select any Inbox> Press [Start] key
16.3.7.1.15 Unable to send scanned documents stored in Inbox
[ Manual-related ]
Field Remedy
This is a specification of this product. If the document you are attempting to send is [Scan Doc.] or [Print Doc.],
it is impossible. If you want to send them, store the document as [System Doc.] in the Inbox by following the
steps below:
Place a document> Press [Send] tab> Press [Store in User Inbox]> Select any Inbox> Press [Start] key
16.3.7.1.16 E-mail cannot be sent: Field of e-mail address of iRC3200 is blank
[ Manual-related ]
< Field Remedy >
E-mail cannot be sent if the e-mail address of iRC3200 is not registered. Register the e-mail address in user
mode [System Settings> Network Settings> E-mail/I-Fax> E-mail Address].
16.3.7.1.17 iRC3200 displays 'Too many jobs are specified.' upon FAX TX, with Resolution Switch
PCB installed
[ Inspected by Canon Inc. ]
< Field Remedy >
As a result of inspection, it was found that the Resolution Switch PCB was faulty. Replace it with a new one.
Resolution Switch PCB: FG3-2728
16.3.7.1.18 When attempting to send FAX, iRC3200 does not dial destination's number after
scanning
[ Case in the field ]
Field Remedy
In this case, this symptom recurred even after installing other Fax board. It was found in the field that the DC
fuse PCB was faulty. Unplug and reinsert the connectors on the DC fuse PCB. If the symptom still recurs,
replace the PCB with a new one.
DC Fuse PCB: FG3-2337
Chapter 16
0004-9847
0004-9875
0005-4293
0005-6107
0005-6176
16-113