12.5
Parts
Procedure
12.5.1 Fixing Drive Unit
12.5.1.1 Removing the Upper
Rear Cover
1) Remove the upper rear cover.
12.5.1.2 Removing the Lower
Rear Cover
1) Remove the lower rear cover.
12.5.1.3 Removing the Left
Upper Rear Cover
1) Removing the left rear upper cover.
12.5.1.4
Removing
Controller Box Cover
1) Disconnect the connector J1512 [1] from the power
distribution PCB, and free the harness from the
wire saddle [2]; then, remove the 6 screws [3], and
detach the main controller cover [4].
F-12-8
Replacement
0000-5127
0000-5128
0000-5131
the
0000-5129
12.5.1.5 Removing the DC
Controller PCB Cover
1) Remove the 8 screws [1], and detach the DC
controller PCB cover [2].
F-12-9
When Attaching the DC Controller PCB Cover
When attaching the cover, take care so that the cut-off
will not come into contact with the latch of the flat
cable. Otherwise, the flat cable can come loose.
[1]
F-12-10
12.5.1.6 Opening the Main
Controller Box
1) Remove the 2 flat cables [1] used to connect the DC
controller PCB and the main controller PCB.
Chapter 12
0000-5130
0000-5132
12-15