Canon iR C3200 Series Service Manual page 508

Chapter 10
F-10-310
2) Remove the 6 screws [1], and remove the base plate
[2]; then, detach the high-voltage unit [3].
F-10-311
10.10.36.13 Removing
Controller Box Cover
1) Disconnect the connector J1512 [1] from the power
distribution PCB, and free the harness from the
wire saddle [2]; then, remove the 6 screws [3], and
detach the main controller cover [4].
10-102
the
0000-4929
F-10-312
10.10.36.14 Removing the DC
Controller PCB Cover
1) Remove the 8 screws [1], and detach the DC
controller PCB cover [2].
F-10-313
When Attaching the DC Controller PCB Cover
When attaching the cover, take care so that the cut-off
will not come into contact with the latch of the flat
cable. Otherwise, the flat cable can come loose.
0000-4930