9) When the results of the registration have appeared, press "OK"
19.2.2 Making Connections
You will be connecting the PC to the machine.
Before Starting the Work
Keep the following on hand:
- PC to which SST v1.61 or later has been installed and iRC3200 firmware has been registered
- Twisted pair 10Base-T (category 3 or 5)
Cross cable 100Base-TX(category 5)
Procedure
1) Start up the PC.
2) Check the network settings of the PC.
Type "IPCONFIG" in response to the command prompt, and press the Return key.
Check to see that the network settings are as follows:
IP address: 172.16.1.160 (other than 172.16.1.0, 172.16.1.100, 172.16.1.255)
Subnet mask: 255.255.255.0
Default gateway: any
F-19-12
Chapter 19
0000-5453
19-11