Canon iR C3200 Series Service Manual page 1104

Chapter 18
PRNT-ORD
Used to switch order of output to side tray.
Whenever possible, avoid using this setting during normal operation.
SLPOFF01 to 12
Used to turn sleep mode OFF as way to eliminate condensation: January to December.
Whenever possible, avoid using these settings during normal operation.
INTPPR-1
Sets interval (number of sheets) for executing image stabilization control (adjustment set 1) between sheets.
0.50 to 1000 (Value at time of factory shipment/value after RAM clear: 100)
DWNSQ-SW
Used to improve tray loading during one-sided continuous printing.
Whenever possible, avoid using this setting during normal operation.
IMG-OFF
Forcibly adds trailing-edge blank on second side of two-sided sheets.
Whenever possible, avoid using this setting during normal operation.
PRN-FLG
Used to select area flag for PDL images.
Whenever possible, avoid using this setting during normal operation.
SCN-FLG
Used to select area flag for copy images.
Whenever possible, avoid using this setting during normal operation.
T-LW-LVL
Used to switch timing for display of remaining toner volume warning message.
Whenever possible, avoid using this setting during normal operation.
DVTGT-Y/M/C/K
developer concentration target value offsets
Whenever possible, avoid using these settings during normal operation.
NWERR-SW
Used to select whether to display network error messages.
0: Don't display
1: Display (value at time of factory shipment/value after RAM clear)
FX-SPD
Used to adjust fixing roller speed.
-2 to 2 (Value at time of factory shipment/value after RAM clear: 0)
Increasing the setting value increases the fixing roller's speed (in 0.8% increments).
Setting this value automatically increases the operation speed of the paper delivery vertical path motor (the speed
increases by the same ratio as the speed of the fixing roller).
EX-PS-SP
Used to adjust paper delivery vertical path motor speed.
-2 to 2 (Value at time of factory shipment/value after RAM clear: 0)
FX-N-ROT
Used to turn fixing motor idle after warmup ON/OFF.
18-98
0006-1214
0006-1215
0006-1216
0006-1219
0006-1222
0006-1223
0006-1225
0006-1226
0006-1228
0006-1229
0006-1232
0006-1233
0006-1236