Adjusting The Left/Right Margin (No.311 Left/Right Margin Adjustment) - Canon NP6621 Service Handbook

b. Pick-Up from the Multifeeder
Loosen the screw
the tray so that the measurement is 0 ±1.5 mm.
Figure 2-205
c. Duplexing Pick-up
Start service mode (No. 329), and make adjust-
ments so that the measurement (Figure 2-204) is 0
±1.5 mm.
Unit: 0.27 mm
5 Adjusting the Left/Right Margin
(No. 311 left/right margin adjust-
ment)
Select service mode (No. 311 left/right margin
adjustment), and make adjustments so that the left/
right margin is 2.5 ±1.5 mm when the Test Sheet is
copied in DIRECT.
You must first adjust the "left/right registration"
before making this adjustment.
Making Adjustments
a. Margin (adjusting the width)
1) Select service mode ([3] No. 311).
2) Press the Start key.
3) Enter the new setting using the numeric key-
pad.
• If the value is negative, '%' is flashed.
To enter a negative value, press the % key,
and then enter the value using the numeric
keypad.
The following describes the relationship be-
tween the settings and the margin:
• For each '1' in the setting, the margin changes
to the side by about 0.37 mm.
• The settings may be between 0 and 15 mm.
• '+' increases the margin.
• '-' decreases the margin.
, and move the position of
q
STANDARDS AND ADJUSTMENTS
Shutter
Figure 2-206
b. Adjusting the Position of the Left/Right
Margin
Turn the blanking adjusting screw on the ma-
chine front side plate shown in Figure 2-207 so that
the dimension is as specified:
CW: moves the margin to the front.
CCW: moves the margin to the rear.
full turn: moves the margin by about 1 mm.
Figure 2-207
Shutter
Figure 2-208
Note:
For both a. and b., turn ON and OFF the power
switch after making the adjustments or try a
different reproduction ratio to move the home
position of the blank exposure assembly.
Adjust the distance between the
two shutters in the blanking
assembly.
q
The entire shutters are
shifted.
2–3