F-9-107
9.8.4 Developing Motor (Bk)
9.8.4.1 Removing the Upper
Rear Cover
1) Remove the upper rear cover.
9.8.4.2 Removing the Lower
Rear Cover
1) Remove the lower rear cover.
9.8.4.3
Removing the Left
Upper Rear Cover
1) Removing the left rear upper cover.
9.8.4.4
Removing
Controller Box Cover
1) Disconnect the connector J1512 [1] from the power
distribution PCB, and free the harness from the
wire saddle [2]; then, remove the 6 screws [3], and
detach the main controller cover [4].
0006-7766
0006-7773
0000-4575
the
0000-4576
F-9-108
9.8.4.5
Removing
Controller PCB Cover
1) Remove the 8 screws [1], and detach the DC
controller PCB cover [2].
F-9-109
When Attaching the DC Controller PCB Cover
When attaching the cover, take care so that the cut-off
will not come into contact with the latch of the flat
cable. Otherwise, the flat cable can come loose.
Chapter 9
the
DC
0000-4577
9-63