Canon iR C3200 Series Service Manual page 1105

0: ON (idle) (value at time of factory shipment/value after RAM clear)
1: OFF (don't idle)
Setting this value to 1 increases the amount of paper curl, and reduces the capacity for the load on the paper delivery
tray.
FX-SUB
Sets the fixing sub-heater's lighting ratio.
0: Normal (value at time of factory shipment/value after RAM clear)
1: Level 1
2: Level 2
Increasing this setting value decreases the lighting ratio (shortens the lighting time).
SLV-UP
Used to increase developing cylinder operation speed.
0: Normal (value at time of factory shipment/value after RAM clear)
1: Operate developing cylinder at 120% of normal speed.
2: Operate developing cylinder at 120% of normal speed and expand interval between sheets as well.
Setting this value to 2 decreases productivity ( -> 24 ppm).
STS-PORT
Used to turn TOT asynchronous status communication port ON/OFF.
For future expansion
CMD-PORT
Used to turn TOT synchronous command communication port ON/OFF.
For future expansion
BK-4CSW
Used to select color mode used in photo mode.
0: OFF (Use monochrome mode when reading monochrome documents in printed photo or photographic printing
paper photo mode.)
1: ON (Use simple color mode when reading monochrome documents in printed photo or photographic printing
paper photo mode.)
Instead of creating monochrome images in 4 colors, simple color mode applies only a very small amount of Y/M/C
toner to the ITB.
NEGA-GST
Additional Setting to the Sequence of Preconditioning Exposure (except laser)
0: OFF
1: ON (preconditioning exposure during initial rotations only)
2: ON (Preconditioning exposure during initial rotations and paper interval)
[Factory Setting/ Setting after RAM-clear]
Reference
Problem occurring when "2" is selected:
- Lower Productivity (=> delay by 2 or 3 seconds)
Chapter 18
0006-1238
0006-1239
0006-1240
0006-1241
0006-1242
0006-5164
18-99