Canon iR C3200 Series Service Manual page 854

Chapter 16
Items to Check
The drum life can be checked in the following service mode.
Service mode level 1 COPIER > DISPLAY > MISC > Y, M, C, K-DRM-LF
Drum unit life (Y/M/C/K ) appropriate range is 0 to 100.
Field Remedy
The default settings can be changed according to the following service mode:
*Service mode level 1 COPIER > OPTION > BODY >DLIFE-SW
Whether or not the degree of wear of the photosensitive drum is displayed.
0: not displayed [factory setting/post-RAM clear value)]
1: displayed (the degree of wear of the drum unit is displayed on user screen under 'System status' >
'Consumables'.
*Service mode level 2 COPIER > OPTION > USER > P-CRG-LF
Whether or not the drum unit is suspended when it has reached to the drum life.
0: not suspended [factory setting/post-RAM clear value]
1: suspended
(Method 1) DLIFE-SW '1', P-CRG-LF '1'
In the user screen, under 'System status' > 'Consumables', the degree of wear is shown in the form of a progress
bar (showing the amount of life remaining). Also, a warning is given at 90% and a message 'Replace drum (all
colors)' is shown at 100% and the machine will be suspended.
(Method 2) DLIFE-SW '0', P-CRG-LF '1'
In the user screen, under 'System status' > 'Consumables', the degree of wear is NOT shown in the form of a
progress bar. Also, when the drum life reaches 100%, the error lamp flashes red and the machine will be
suspended.
(Method 3) DLIFE-SW '1', P-CRG-LF '0'
In the user screen, under 'System status' > 'Consumables', the degree of wear is shown in the form of a progress
bar (showing the amount of life remaining). Also, even when the drum life has exceeded 100%, the machine
will not be suspended and still can be used.
(Method 4) DLIFE-SW '0', P-CRG-LF '0' (default settings)
In the user screen, under 'System status' > 'Consumables', the degree of wear is NOT shown in the form of a
progress bar. Also, even when the drum life has exceeded 100%, the machine will not be suspended and still
can be used.
16.3.4.6.5 When an arbitrary paper size is programmed in user mode [Common Settings>Stack
Bypass Standard Settings], paper of different paper sizes cannot be copied from the manual feed
tray.
Symptom
When an arbitrary paper size is programmed into user mode > common spec. settings > manual feed paper
standard mote registration, different sized paper is set in the manual feed tray and copies cannot be made.
Cause
If you register optional paper size in " User Mode> Common Specification Setting > Standard Mode
Registration for Manual Feed Paper", you can make a copy only on the registered size paper through manual
feeding. This is specified on this machine.
16-80
0002-3350