Removing The Dc Controller Mounting - Canon iR C3200 Series Service Manual

9.8.16.8 Removing the DC
Controller Mounting
1) Disconnect all connectors from the PCB, and free
all harnesses from the cable clamps; then, remove
the 7 screws [1], and detach the DC controller PCB
[2] together with its base.
F-9-247
9.8.16.9 Removing the Toner
Container Drive Unit
1) Disconnect the connector from the relay PCB 1,
and feed the harness of the developer motor from
the cable clamp; then, remove the 4 screws [1], and
detach the relay PCB 1 together with its base [2].
F-9-248
2) Disconnect the 2 connectors [1], and remove the 3
screws [2]; then, detach the toner container drive
unit [3].
0000-4597
9.8.16.10 Removing the Toner
Container Drive Assembly
Upper Plate
1) Remove the screw [1], 2 E-rings [2], and 2 bushings
[3]; then, free the harness from the edge saddle [4];
then, free the harness [5] of the toner container
0000-4598
motor from the cord clamp [6] to detach the toner
container drive assembly top plate [7].
Points to Note When Attaching the Toner
Container Drive Assembly Upper Plate
Chapter 9
F-9-249
0000-4599
F-9-250
9-93