Canon iR C3200 Series Service Manual page 992

Chapter 17
Code
E577
E580
E584
E5F0
17-12
Detail Description
There is a fault in stack processing (counterclockwise direction).
The stack processing motor (M2)
or the return controller home
position sensor (S3) is faulty. The
connector is disconnected. The
stack delivery lever or the return
roller is faulty.
There is a fault in ascent/descent of the stack tray.
The stack tray ascent/descent
motor (M5), stack tray paper
height sensor (S10), or the stack
tray ascent/descent motor clock
sensor (S9) is faulty. The
connector is disconnected. An
excess load is imposed on the
stack tray ascent/descent motor.
There is a fault in feed operation (No. 2).
0001 The No. 2 feed motor (M8) or the
shutter open sensor (PI5) is
faulty.
0002 The No 2 feed motor (M8) or the
shutter closed switch (MS4) is
faulty.
0003 The safety area detecting switch
(MS3) or the shutter closed
switch (MS4) is faulty.
There is a fault in paper positioning for the saddle.
0001 The paper positioning plate
motor (M4S) or the paper
positioning plate home position
sensor (PI7S) is faulty.
0002 The paper positioning plate
motor (M4S) or the paper
positioning plate home position
sensor (PI7S) is faulty.
Timing of detection
The return roller fails to reach the
return roller home position sensor
when the stack processing motor
has been driven for a required
period of time.
The stack tray upper limit sensor
goes ON while the stack tray
ascent/descent motor is in
operation, or the clock pulse of the
stack tray direction motor clock
sensor is not detected 15 times or
more within 0.8 sec.
The stack tray does not reach the
stack tray height sensor within 4 sec
after the stack tray ascent/descent
motor has started ascent operation.
The shutter open sensor does not go
ON when the No. 2 feed motor has
been rotated in reverse for 1 sec or
more.
The shutter closed switch does not
go ON when the No. 2 feed motor
has been rotated in reverse for 1 sec
or more.
The shutter closed switch is OFF
when the tray 1/2 is in the OFF
position of the safety area switch
while the tray ascent/descent motor
is in operation.
The paper positioning plate home
position sensor does not go ON
when the paper positioning plate
motor has been driven for 1.33 sec.
The paper positioning plate home
position sensor does not go OFF
when the paper position plate motor
has been driven for 1 sec.