Making Copies; Using The Manual Feed Tray (Np2020; Using The Manual Feed Tray (Np2120; Making Two-Sided Copies - Canon NP2120 Service Manual

B. Making Copies
If the temperature of the fixing assembly is
below the specified value,
. NP2020
The COPY START key remains red.
. NP2120
The COPY START key flashes green.
If the temperature of the fixing assembly is
key goes green.
The wait time is normally 90 sec (2O"C,
average).
2) Openthecopyboardcover,andplaceadocument
3) Press the DIRECT, REDUCE, ENLARGE, or
ZOOM key for the desired copy size.
4) Press the AE key, and press the COPY DENSITY
key as necessary if manual adjustment is desired.
5) Check the size of the cassette.
paper of the desired size.
6) PresstheTENKEY padtosetthedesirednumber
of copies (1 to 99), and check the COPY COUNT
indicator.
mistake; set the copy count thereafter.
7) Press the COPY START key.
continuous copy operation. the copier stops
after it has completed the copy run.
switched from automatic to manual between
when the operation is started and when the
last copy is completed; however, switching
from manual to automatic is not possible
during the period.
Note:
If the copy is too dar& or light in the AE mode,
de- activate the AE mode, and make copies
DENSITY key.
paper to the cassette; a press on the COPY
START key thereafter causes the copier to
make the remaining number of copies.
placedonthetraywill
pressed.
beautomaticallypicked
the copier returns to the standard mode ti left
alone for about 2 min'.
'Cannot be changed. but may be de-activated.
C. Using the Manual Feed Tray
(NP2020)
2) Press the DIRECT, REDUCE, ENLARGE, or
ZOOM key.
3) De-activate the AE mode, and adjust the density
using the COPY DENSITY lever if manual
adjustment is desired.
4) Feed a sheet of copy paper along the guides on
the manual tray.
soon as it detects the copy paper.
mm or more if in the continuous copy mode.
Note:
When the ADD PAPER indicator is ON, the
COPY READY indicator is red; manual feed
operation, however, is still possible.
. Using the Manual Feed Tray
(NP21 20)
1) Set the document on the copyboard.
2) Open the manual feed tray.
3) Set the slide guide to suit the paper size.
Note:
Slide out the sub tray as necessaty to suit
larger paper sizes.
4) Insert as many sheets as necessary along the
guide until they stop; keep the face of the copy
paper up.
E. Making Two-Sided Copies
Make sure that the copy is oriented the same way
(front and rear) for both first and second sides: keep
the following in mind:
C A N O N NPZl20/ZMO RN.1 OEC. 1992 PAINTEO I N J A P A N IIMPAIME AU JAPONI