Canon iR C3200 Series Service Manual page 1112

Hide thumbs Also See for iR C3200 Series:

Table of Contents

Switching the developing assembly idle rotation time of first thing in the morning

1: 2 minutes

[Factory default/After RAM clear: 0]

Default of idle rotation time is 1 minute since iR C3200/iR C3220 Dcon V12.1 However, use this mode to set 2

minutes if any trouble (faulty image etc.) occurs due to reduction of the time.

Use it to enable/disable E code indication of a low temperature error

The new setting will not be valid until the power switch has been

turned off and then on again

1: do not indicate

at time of shipment/upon RAM initialization: 0

Setting up a threshold for the accumulated number of outputs for the Dhalf control

sequence operation trigger.

If the fixing unit is lower than a specified temperature when the machine is turned on

or recovered from the sleep mode, use this mode to make automatic full adjustments

during initial multiple rotations.

At this time, the Dhalf control is performed only if the number of outputs accumulated

since the last Dhalf control exceeds the value specified in this Service Mode.

Changing the timing of or canceling the Dhalf control (according to the number of

accumulated outputs) by using this mode can reduce the downtime in the morning. (A

measure for a complaint about the downtime in the morning)

Meanwhile, there is a possibility that gray scale (half-tone image) might be degraded

when the Dhalf control is cancelled.

With regard to the accumulated number of outputs, a small-size copy is regarded as 1

count, and a large-size copy is regarded as 2 counts.

When the Dhalf control is performed first thing in the morning or from the User Mode

(quick correction, full correction), the accumulated number of outputs is reset.

1 to 5000 [Initial setting upon shipment/value after RAM clear: 1000]

Show Quick Links

Chapters

Table of Contents

Ir c3220n prt