Chapter 11
5) Remove the shaft [1] (used to secure the fixing
upper frame/lower frame) in place and the gear [2].
F-11-102
6) Remove the shaft [1] (used to secure the fixing
upper frame/lower frame) at the front.
F-11-103
7) Separate the fixing upper frame and the lower
frame, and detach the fixing upper frame [1].
F-11-104
11-36
11.5.6.4 Removing the Fixing
Sub thermistor
1) Remove the screw [1], and detach the fixing sub
thermistor [2].
F-11-105
11.5.6.5 After Disassembling
the Fixing Unit
If you have loosened the adjusting screw used to
secure the upper frame and the lower frame of the
fixing unit in place (as when replacing a roller), be
sure to adjust the nip of the fixing roller as follows:
1) Turn the adjusting screw [1] at the front/rear so that
the length of the pressure spring is 31.5mm.
F-11-106
0000-5082
0000-5083