Fixing Assembly; Removing The Fixing Assembly; Opening The Fixing Upper Roller Unit - Canon 1130 Service Manual

CHAPTER 8 FIXING SYSTEM
A. Fixing Assembly

1. Removing the Fixing Assembly

1) Open the front cover.
2) Remove the fixing cover.
3) Slide out the transfer drum frame.
4) Grasp the front and rear handles of the
fixing assembly, and lift it to detach.
2. Opening the Fixing Upper Roller
Unit
1) Open the front cover.
2) Remove the fixing cover.
3) Slide out the transfer drum frame.
4) Remove the two screws [1], and detach
detection fixing upper cover [2].
5) Open the inside delivery assembly
(fixing delivery assembly).
6) While keeping the joint of the screw [3] in
place with radio pliers to prevent shaving of
each screw, remove the two screws [3], and
detach the fixing upper roller unit [4].
When closing the fixing
upper roller unit, try lift-
ing the oil applying felt
slightly with your finger.
At that time, take care so
that the oil pipe will not
slide out of the groove.
8-14
COPYRIGHT © 2002 CANON INC.
[2]
CANON CLC1100/1130/1150/1160/1180 REV.1 FEB. 2002 PRINTED IN JAPAN (IMPRIME AU JAPON)
Figure 8-401
[1]
Figure 8-402
[3] [4]
Figure 8-403
[1]
[3]