Chapter 1: Before you install
Read this chapter carefully before you begin the installation. If you are installing the G350 at a
customer site, read this chapter before going to the customer site.
Before going to site
Before going to the site, it is necessary to read the planning documentation and prepare
equipment required for installation.
Preparing required equipment
Make sure you have the necessary equipment to assist you in the installation before you start
working.
Equipment required for installation
One loop start analog trunk for connecting a modem
●
A separate telephone line, if needed, for verbal communication during remote
●
configuration
Equipment required for mounting
A crosspoint screwdriver if rack mounting or wall mounting the G350
●
If you will mount the G350 on a flat wall: screws to fasten the G350 to the wall
●
If you will mount the G350 on a non-flat wall:
●
- A 48 in. x 48 in. (1.2 m x 1.2 m) plytwood board (US: 3/4 inch plywood), 0.75 in. (20
mm) thick.
- Wood screws to fasten the G350 to the plywood.
- Screws to fasten the plywood board to the wall (pan head at least ¾ in, #10-12 screw)
Equipment required for installing an S8300 Server
One USB CD-ROM drive
●
Issue 7 November 2009
17