Cordless Headset Installation And Registration; Sb35025 Deskset Registration - AT&T Syn248 SB35010 Installation And Configuration Manual

Syn248 Installation and Configuration Guide

Cordless Headset Installation and Registration

Install the cordless headset charger, then install and charge the battery according to the
headset user's manual.
You can register one AT&T DECT Cordless Headset to a Deskset. When a Deskset has a
cordless accessory, the Deskset and headset are all part of the same extension, and only
one device can be used at a time.
The headset must be in the charger, fully charged and deregistered from any
other device before registration can proceed. Remove and replace the cordless
headset before you press

SB35025 Deskset Registration

To register the cordless headset:
1. On the Deskset, press
The Cordless Headset menu appears.
2. Remove and replace the cordless headset from its charging base.
3. Press
for the headset.
4. When registration is complete, Headset is registered appears.
5. Press
Installation
The SB35020 Deskset does not support AT&T DECT Cordless Headsets.
(MENU), then 2, and then 6.
. Registration in Progress... appears while the Deskset searches
Register
(CANCEL). The User Settings menu appears.
While registration is in progress, registration can be terminated by pressing
(CANCEL) on the Deskset.
If the cordless headset is registered to another Deskset, it must be
deregistered first. See "Deregistering a Cordless Headset" on page
on the Deskset.
Register
30
Back to Contents
32.