Connecting The Mx104 Router To External Devices; Connecting The Mx104 Router To Management Devices; Connecting The Router To A Network For Out-Of-Band Management; Figure 19: Ethernet Cable Connector - Juniper MX104 Hardware Manual

CHAPTER 9
Connecting the MX104 Router to External
Devices

Connecting the MX104 Router to Management Devices

Connecting the Router to a Network for Out-of-Band Management

Copyright © 2014, Juniper Networks, Inc.
Connecting the MX104 Router to Management Devices on page 59
Connecting the MX104 Router to External Clocking and Timing Devices on page 61
Connecting the MX104 Router to an External Alarm-Reporting Device on page 62
Connecting Interface Cables to MX104 Routers on page 63
To connect external devices and cables to the router, you need the following tools:
RJ-45 Ethernet cable and RJ-45 to DB-9 serial port adapter (provided)
Management host, such as a PC, with an Ethernet port (not provided)
The following topics provide instructions for connecting the router to management
devices:
Connecting the Router to a Network for Out-of-Band Management on page 59
Connecting the Router to a Management Console Device on page 60
To connect to the
ETHERNET
Turn off the power to the management device.
1.
Plug one end of the Ethernet cable into the
2.
(Figure 19 on page 59 shows the connector.
Plug the other end of the cable into the network device.
3.

Figure 19: Ethernet Cable Connector

port on the MX104 Routing Engine:
port on the Routing Engine.
MGMT
Figure 20 on page 60 shows the port.)
59