Powering Off The Mx240 Router; Connecting The Mx240 Router To The Network - Juniper MX240 Hardware Manual

MX240 5G Universal Routing Platform Hardware Guide

Powering Off the MX240 Router

See Also

Connecting the MX240 Router to the Network

206
NOTE: The circuit breaker may bounce back to the off (
move the breaker too quickly.
Observe the status LEDs on the power supply faceplate. If the power supply is correctly
installed and functioning normally, the
green steadily.
NOTE: After powering off a power supply, wait at least 60 seconds before
turning it back on.
To power off the router:
On the external management device connected to the Routing Engine, issue the
1.
request system halt both-routing-engines
shuts down the Routing Engines cleanly, so their state information is preserved. (If
the router contains only one Routing Engine, issue the
user@host> request system halt both-routing-engines
Wait until a message appears on the console confirming that the operating system
2.
has halted. For more information about the command, see the
Attach an ESD grounding strap to your bare wrist and connect the strap to one of the
3.
ESD points on the chassis.
Move the AC input switch on the chassis above the AC power supply or the DC circuit
4.
breaker on each DC power supply faceplate to the off (
Preventing Electrostatic Discharge Damage to an MX240 Router on page 380
Tools and Parts Required for MX240 Router Connections on page 207
Connecting the MX240 Router to a Network for Out-of-Band Management on page 207
Connecting the MX240 Router to a Management Console or Auxiliary Device on page 207
Connecting the MX240 Router to an External Alarm-Reporting Device on page 208
Connecting DPC, MPC, MIC, or PIC Cables to the MX240 Router on page 209
, , and
PWR OK BRKR ON INPUT OK
operational mode command. The command
request system halt
CLI Explorer
) position.
0
Copyright © 2019, Juniper Networks, Inc.
) position if you
O
LEDs light
command.)
.