Reinstalling Components In The Mx240 Router After Installing It With A; Lift; Reinstalling The Power Supplies After Installing The Mx240 Router With; Reinstalling The Fan Tray After Installing The Mx240 Router With A - Juniper MX240 Hardware Manual

Reinstalling Components in the MX240 Router After Installing it with a Lift
Copyright © 2019, Juniper Networks, Inc.
Move the lift away from the rack.
7.
Install a mounting screw into each of the open mounting holes aligned with the rack,
8.
starting from the bottom.
Visually inspect the alignment of the router. If the router is installed properly in the
9.
rack, all the mounting screws on one side of the rack should be aligned with the
mounting screws on the opposite side and the router should be level.

Figure 53: Installing the Router in the Rack

NOTE: This illustration depicts the router being installed in an open-frame
rack. For an illustration of the mounting hardware required for a four-post
open rack or open cabinet, see
Hardware for a Rack or Cabinet" on page
After the router is installed in the rack, you reinstall the removed components before
booting and configuring the router. The following procedures describe how to reinstall
components in the chassis, first in the rear and then in the front:
Reinstalling the Power Supplies After Installing the MX240 Router with a Lift on page 180
1.
Reinstalling the Fan Tray After Installing the MX240 Router with a Lift on page 180
2.
Reinstalling the SCBs After Installing the MX240 Router with a Lift on page 181
3.
Chapter 3: Initial Installation and Configuration
"Installing the MX240 Router Mounting
170.
179