T320 Core Router Hardware Guide
Reinstalling the T320 Power Supplies
146
Figure 55: Reinstalling a SIB
If the T320 router has two power supplies, reinstall the lower power supply first, then the
upper power supply. To reinstall the power supplies (see
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
Switch the circuit breaker on the power supply faceplate to the off position (
2.
Using both hands, slide the power supply into the chassis until you feel resistance.
3.
Twist the ejector handles at the upper corners of the power supply faceplate clockwise
4.
until they stop.
Tighten the captive screws at the lower corners of the power supply faceplate to
5.
secure the power supply in the chassis.
Repeat the procedure for the upper power supply.
6.
Figure 56 on page
147):
O
Copyright © 2018, Juniper Networks, Inc.
).