Mitsubishi NZ2GFCF-D62PD2 User Manual page 280

(17)Station-based control data (address: 1002
Address Name
Parameter area
1002
initialization
H
command
● When Parameter area initialization command (address: 1002
remote registers are not cleared. (Note that the following are the target data to be cleared by Initial data setting request
flag (RY9).)
• Warning status flag (RX7)
• Error status flag (RXA)
• CH Error status (RX36, RX4E)
• CH Warning status (RX37, RX4F)
• CH Latest error code (RWr22, RWr3A)
• CH Latest warning code (RWr23, RWr3B)
● When initialization of the parameter information and the extended parameter information is completed, Initial data
processing request flag (RX8) turns on. Set parameters using Initial data setting request flag (RY9) and remote registers
using Initial data processing completion flag (RY8).
278
• The parameter information and the extended parameter information stored in
the remote buffer memory and the nonvolatile memory are initialized by this
command.
• The following shows the setting range.
b15 b14 b13 b12 b11 b10 b9
0 0 0 0 0 0 0
0 (fixed)
• When Parameter area initialization command (address: 1002
Commanded (1), the parameter information and the extended parameter
information stored in the remote buffer memory and the nonvolatile memory
are initialized and Parameter area initialization completed (address: 1003
changes to Initialization is completed (1).
Controlled by the high-speed counter module
Controlled by the program
Parameter (remote
buffer memory and
Set parameter
nonvolatile memory)
Parameter area
initialization command
Not commanded (0)
(address: 1002 )
H
Parameter area
initialization completed
(address: 1003 )
H
)
H
Description
b8 b7 b6 b5 b4 b3 b2 b1
0 0 0 0 0 0 0 0
Default value
Commanded (1)
Completed
Not performed (0)
) is executed, the following remote input signals and
H
Default
b0
0: Not
commanded
1: Commanded
) is set to
H
)
H
0000
H
Not commanded (0)
Not
(1) performed (0)