7.2.2
Changing the parameter without changing the network
configuration
To change only the created module parameter of the slave station without changing the network configuration, set the
parameter in the following procedure.
1.
Display the "CC IE Field Configuration" window.
• When the master/local module is the QJ71GF11-T2
Project window
• When the master/local module is the LJ71GF11-T2
Project window
2.
Select the high-speed counter module in "List of stations" on the "CC IE Field Configuration"
window.
List of stations
3.
Open the "Parameter Processing of Slave Station" window.
[CC IE Field Configuration]
4.
Set "Parameter read" for "Method selection".
5.
Click the
88
[Parameter]
[Network Parameter]
button
[Parameter]
[Network Parameter]
button
[Parameter Processing of Slave Station]
button to read the parameter from the high-speed counter module.
[Ethernet/CC IE/MELSECNET]
[Ethernet/CC IE Field]