● The count value cannot be replaced with the preset value while CH External preset/replace (Z Phase) request
detection (RX23, RX3B) is on.
Replace the value after CH External preset/replace (Z Phase) request detection (RX23, RX3B) turns off by turning on
CH External preset/replace (Z Phase) request detection reset command (RY23, RY3B).
● Have a ΔT
value is replaced since there are maximum of ΔT
RWw2C to RWw2D) is reflected. For ΔT
144
or longer interval after changing CH Preset value setting (RWw14 to RWw15, RWw2C to RWw2D) until the
1
delay until change in CH Preset value setting (RWw14 to RWw15,
1
, refer to Page 283, Appendix 4.
1