7.
Display the "Parameter Processing of Slave Station" window and change "Method selection" to
"Parameter write" to set the following.
[Ethernet/CC IE/MELSECNET]
Select a high-speed counter module in "List of stations"
8.
Click the
(7) Setting method of the program
1.
Create a program in Page 193, Section 9.3 (8) to Page 202, Section 9.3 (13) on GX Works2
according to the mode or function to use.
2.
Write the program to the CPU module of the master station and reset the CPU module, or turn off
then on the power supply.
3.
Change the status of the CPU module of the master station to RUN.
192
[Parameter Processing of Slave Station]
button to write the parameter to the high-speed counter module.
RESET
[CC IE Field Configuration]
or Power OFF
ON
RUN
button